Stomra · Guide
The ground cut by what is built in it
The finished ground stops at the building by itself: a basement or a slab in a slope is empty of soil in every view.
What it does
The site's finished ground is a surface over the whole plot. Where a building reaches under it, a basement or a floor laid in a slope, the ground has to stop at the building. Stomra does this by itself: whatever is built in the ground cuts it away along its own outline. Move a wall or a foundation and the cut follows.
You never have to lay a pad or a flattened area under a house to clear the ground out of it. A pad meant for that purpose leaves a step in the ground that reads as a retaining wall, and it stays behind when the building moves. Let the cut do it.
What cuts the ground
| Element | How it cuts |
|---|---|
| A floor, or a foundation that holds a room | From its underside up: the room above it is empty of ground. |
| A wall, a column or a slab edge that reaches under the ground | Where it stands, through the ground, along its own outline. |
| A footing or strip foundation that the ground covers | Keeps the ground over it, out to its wall's face. |
| Outdoor stairs and beams | Do not cut. |
Set a clearance
By default the ground lies right against the walls and foundations. To cut it back further, for example to show a working gap round a basement:
- Open the site's properties in the Inspector.
- Set Clearance to how far outside what is built the ground is cut away, from 0 to 500 mm.
The gap is drawn in every view, down to the underside of what is built, and its outer corners are rounded by the clearance. The clearance is one value for the whole project.
One cut, in every view
The cut is one thing in the model, so it looks the same everywhere the finished ground shows: the 3D view, walk mode, the client portal, sections, elevations, plans and sheets.
Quantities
The cut is drawn, not counted. The graded ground's quantities, the pits dug for foundations and the site's warnings are worked out as before, and the site report says how many elements cut the ground.
Good to know
- Garden soil laid over a buried deck slab is cut away too.
- A sloping body cuts level, at its lowest point.
- An element's own holes are not read by the cut.
The building's phases, including the site phase, are described in Phases: the building over time.
Placing the project on a map, bringing in the ground, pads, falls and the excavation rules are in The site: place, ground and grading.